- 이메일
- 전화
-
주소
Shangyou Mansion, Longhua District, Shenzhen 1821-1822
제품 카테고리
Shenzhen Junhui Electronics Co., Ltd
개요
Introduction to RSA5065N Universal 6.5GHz Spectrum Analyzer $r $n $r $nRSA5000 Real time Spectrum Analyzer, equipped with Real time Analysis (RTSA), Sweep Frequency Analysis (GPSA) functions and Vector Network Analysis mode (VNA, N models only), optional Vector Signal Analysis Application Software (VSA) and EMI Measurement Application Software (EMI), with excellent performance and indicators.
제품 정보
RSA5065N Universal 6.5GHz Spectrum Analyzercharacteristic
⚫ Adopting Ultra Real technology
⚫ The frequency range can reach up to 6.5 GHz
⚫ Display average noise level DANL<-165 dBm (typical value)
⚫ Phase noise<-108 dBc/Hz (typical value)
⚫ Level measurement uncertainty<0.8 dB
⚫ Tracking source with a maximum frequency of 6.5 GHz
⚫ Resolution bandwidth RBW minimum is 1 Hz
⚫ Support EMC filter and quasi peak detector functions
⚫ Equipped with rich advanced measurement functions
⚫ Capable of multiple measurement modes
⚫ Up to 40 MHz real-time analysis bandwidth
⚫ Multiple trigger modes and trigger templates
⚫ Provide multiple display modes such as probability density spectrum and spectrum, presenting real-time measurement results
⚫ Optional upper computer software
⚫ 10.1-inch multi touch screen, supporting gesture operation
⚫ Communication and display interfaces such as USB, LAN, HDMI, etc
RSA5065N Universal 6.5GHz Spectrum Analyzer
technical indicators
The technical specifications are applicable to the following conditions: the instrument is within the calibration cycle, stored at a temperature of 0 ℃ to 50 ℃ for at least two hours, and preheated for 40 minutes. The data in this manual, unless otherwise specified, are technical indicators that include measurement uncertainty. Typical value: Refers to the typical performance that can be achieved by 80% of the test results at room temperature (about 25 ℃). This data is not guaranteed and does not include measurement uncertainty. Nominal value: represents the expected average performance or design performance characteristics, such as a 50 Ω connector. This data is not guaranteed and was measured at room temperature (approximately 25 ℃). Measurement value: represents the performance characteristics measured during the design phase, which can be compared with expected performance, such as amplitude drift over time. This data is not guaranteed and was measured at room temperature (approximately 25 ℃). Note: Unless otherwise specified, all charts in the manual are derived from measurements taken by multiple instruments at room temperature. In addition, besides tracking source indicators, the indicators listed in this manual are for tracking source closure situations.
